XC6124E641ER-G belongs to the category of voltage regulators.
It is used to regulate and stabilize voltage levels in electronic circuits.
XC6124E641ER-G comes in a small SOT-23-5 package.
The essence of XC6124E641ER-G is to provide a stable and regulated voltage supply to electronic devices.
XC6124E641ER-G is typically packaged in reels, with each reel containing 3000 units.
XC6124E641ER-G has the following pin configuration:
XC6124E641ER-G operates by comparing the output voltage with a reference voltage and adjusting the internal circuitry to maintain a stable output voltage. It uses feedback control to regulate the voltage and compensate for any variations in input voltage or load conditions.
XC6124E641ER-G is commonly used in various electronic devices, including:
It is particularly useful in applications where a stable and regulated power supply is essential for proper device operation.
Some alternative models that can be considered as alternatives to XC6124E641ER-G are:
These alternative models offer similar functionality and can be used as replacements depending on specific requirements.
Word count: 411 words
Sure! Here are 10 common questions and answers related to the application of XC6124E641ER-G in technical solutions:
Question: What is XC6124E641ER-G?
- Answer: XC6124E641ER-G is a voltage detector IC (integrated circuit) manufactured by Torex Semiconductor. It is used to monitor the voltage level of a power supply and provide an output signal when the voltage falls below a certain threshold.
Question: What is the operating voltage range of XC6124E641ER-G?
- Answer: The operating voltage range of XC6124E641ER-G is typically between 0.8V and 6.0V.
Question: How does XC6124E641ER-G work?
- Answer: XC6124E641ER-G works by comparing the input voltage with a reference voltage. When the input voltage drops below the reference voltage, the output pin of the IC becomes active, indicating a low voltage condition.
Question: What is the output type of XC6124E641ER-G?
- Answer: XC6124E641ER-G has an open-drain output type, which means it can sink current but cannot source current. An external pull-up resistor is required to provide a logic high level on the output pin.
Question: What is the typical quiescent current consumption of XC6124E641ER-G?
- Answer: The typical quiescent current consumption of XC6124E641ER-G is very low, usually around 1.0µA.
Question: Can XC6124E641ER-G be used in battery-powered applications?
- Answer: Yes, XC6124E641ER-G is suitable for battery-powered applications due to its low quiescent current consumption, which helps to conserve battery life.
Question: What is the hysteresis voltage of XC6124E641ER-G?
- Answer: The hysteresis voltage of XC6124E641ER-G is typically 0.1V, which means the output will remain active until the input voltage rises above the threshold voltage plus the hysteresis voltage.
Question: Can XC6124E641ER-G be used in automotive applications?
- Answer: Yes, XC6124E641ER-G is AEC-Q100 qualified and suitable for automotive applications, providing reliable voltage monitoring and protection.
Question: Does XC6124E641ER-G have built-in overvoltage protection?
- Answer: No, XC6124E641ER-G does not have built-in overvoltage protection. It is designed primarily for undervoltage detection.
Question: What is the package type of XC6124E641ER-G?
- Answer: XC6124E641ER-G is available in a SOT-25 package, which is a small surface-mount package with 5 pins.
Please note that the answers provided here are general and may vary depending on the specific datasheet and application requirements.